Marvel ML15BCG2LS Manuel et guide de l'utilisateur télécharger pdf (Page 13)

Step 2: Remove the door gasket

With the door laying on a at surface and starting at a

corner of the door remove the magnetic door gasket from

the interior side of the door, see Figure 13. Set the gasket

aside on a at surface.

There are 10 holes in the gasket retainer extrusions, (3 on

each side and 2 at the top and bottom which are used to

fasten the panel to the front of the door. The screws are

provided in the literature pack along with the door lock,

which is provided on certain models.

Figure 12

Press and hold down this

tab on the wire connec-

tor and pull the connector

apart.

OVERLAY DOOR PANEL INSTALLATION

Step 3: Cut and drill the overlay panel

Depending on your model cut the overlay door panel to the

dimensions shown in Figure 14 to Figure 17. The window

cut out is for glass door models only.

CAUTION

Weight of overlay door panel must not exceed 15

pounds (6.8 kg) for a solid door model or 10 pounds

(4.5 kg) for a glass door model.

Overlay panel to

be centered on

width of door.

Overlay panel

ush with top

of door.

Magnetic Gasket

remove starting at

a corner, grasp and

pull away from the

door.

Holes in

gasket

retainer.

Figure 13a

Figure 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Pas de commentaire

Marvel ML15BCG2LS Manuel et guide de l'utilisateur Page 13